Creating a lace wigs is a long, meticulous process that can take several hours to several days. Once the wig is complete, the excess lace that hangs over the forehead must be trimmed back into the wigs for the most natural look. This is a delicate process that takes a steady hand, a good pair of scissors and a lot of patience. Since a lace front wig does not reach all the way around to the nape of the neck, this process will be shorter and a little easier than a full wig.

Instructions

1.Find the center of the front of the lace wig and slide the thin hair clip vertically to mark the position. There should be two even lace pieces on each side of the clip.

2. Clip the hair on either side of the center-marking clip back using the two large hair clips. This will keep any stray hairs from being cut.

3. Cut away about a quarter-inch of the lace all around the front and sides of the human hair wigs. Do this using long, fluid scissor strokes to avoid jagged edges. It is best to cut away small portions of lace instead of all of it at once, since cutting away too much lace will ruin the wig.

4. Remove the center-marking clip. Keep the hair clipped back, adjusting the clips as necessary.